Bu dosya Wikimedia Commons deposunda bulunmaktadır ve diğer projeler tarafından kullanılıyor olabilir.
Aşağıda dosya açıklama sayfasındaki açıklama gösteriliyor.
Figure 328: A large current low voltage bipolar dynamo built for electrolytic work and here shown to illustrate the large size commutator and brushes necessary to collect the large current.
The machine here illustrated gives 310 amperes at 7 volts when running at a speed of 1400 RPM, corresponding to an output of 2.17 kilowatts.
Carbon brushes would not be suitable for this class of machine because even with copper brushes, whose conductivity is much higher than carbon, the commutator must be of considerable size to give the required brush contact area. The contrast between the axial lengths of the armature and the commutator is very marked.
The rocker construction is of the ordinary type, and heavy flexible cables conduct the current from the brush holders to the fixed terminals.
My Notes
While the size of this device is not listed in the book, the brushes alone are likely to have been 1.5 to 2 inches wide, meaning the commutator is probably a foot wide. The overall machine was probably about three feet tall and about four feet wide, weighing in at several hundred pounds.
The short rod on the left side of the copper brushes is most likely a handle, to allow the operator to rotate the position of the brushes. As the speed of the rotor varies, the ideal position of the brushes changes due to the spinning rotor dragging the field lines around with it.
Yes indeed, carbon brushes were not good enough for high-current applications. This needs to be mentioned in an article somewhere.
Each brush sits in a separate spring-tension carrier, so that as the brush wears away it is pushed down into the commutator to maintain contact.
The screws at the base of the unit were used to adjust the flat-belt tension, by moving the entire frame towards or away from the driving engine.
Public Domain source:
Hawkins Electrical Guide, Volume 1
Chapter 20: Commutation and the Commutator, Page 301.
Lütfen bu dosyanın tanımını değiştirerek bir kaynak ekleyin.
Yazar
Bu dosyanın yazar bilgisine ihtiyacı vardır.
Lisanslama
Public domainPublic domainfalsefalse
Public domain
Bu medya dosyası ve içeriği ABD'de kamu malıdır. Bu durum genellikle ABD'de telif hakkı süresi dolmuş eserler için geçerlidir. Çünkü ilk yayınlanması 1 Ocak 1929 tarihinden önce yapılmıştır. Daha fazla açıklama için bu sayfaya bakınız.
United States
Bu görüntü, Amerika Birleşik Devletleri dışında kamu malı olmayabilir; özelikle ABD eserleri için Kanada, Çin Halk Cumhuriyeti (Hong Kong ya da Makao hariç), Almanya, Meksika ve İsviçre' gibi kısa vadeli kuralı geçerli olmayan ülke ve bölgelerde geçerli değildir. Yayını oluşturan ve tarihi gibi temel bilgiler belirtilmelidir. Daha fazla bilgi için Vikipedi:Kamu malı ve Vikipedi:Telif hakları sayfalarına bakabilirsiniz.
Orijinal yükleme günlüğü
Dosyanın orjinal açıklama sayfası burada bulunmaktadır. Aşağıdaki tüm kullanıcı adları için en.wikipedia bakın.
2008-01-14 08:07 DMahalko 2439×1953× (425594 bytes) == Summary == Text from public domain illustration: Figure 328: A large current low voltage bipolar dynamo built for electrolytic work and here shown to illustrate the large size commutator and brushes necessary to collect the large current. * The machin
Altyazılar
Bu dosyanın temsil ettiği şeyin tek satırlık açıklamasını ekleyin.
{{Information |Description={{en|Text from public domain illustration: Figure 328: A large current low voltage bipolar dynamo built for electrolytic work and here shown to illustrate the large size commutator and brushes necessary to collect the large cur
Bu dosyada, muhtemelen fotoğraf makinesi ya da tarayıcı tarafından eklenmiş ek bilgiler mevcuttur. Eğer dosyada sonradan değişiklik yapıldıysa, bazı bilgiler yeni değişikliğe göre eski kalmış olabilir.